Automatic Grease Lubrication Systems
The right grease, in the right amount, at the right time, on every bearing, every shift.

A large share of bearing failures start with lubrication: too little grease, too much, the wrong type, or grease that’s dirty before it ever reaches the bearing. Manual greasing routes make all four easy to get wrong.
Flexaseal’s automatic lubrication systems replace the grease gun with steady, metered delivery. They’re backed by the same rotating-equipment reliability experience behind our mechanical seals, so you get lubrication that’s matched to your equipment, not just a device on a fitting.
Why Manual Greasing Falls Short
A grease gun and a route sheet only work when the right person reaches the right fitting on time, and gets the dose right. In practice, that rarely happens on every point, every interval.
- Over-greasing churns the grease, raises bearing temperature, and can push past seals or into motor windings.
- Under-greasing from missed or late intervals starves the bearing and speeds up wear.
- Contamination from open pails, dirty fittings, and shared grease guns carries dirt and water straight into the bearing.
- Safety exposure puts technicians next to moving, elevated, or guarded equipment to reach hard-to-access points.
- Labor goes to walking routes instead of higher-value maintenance work.
Automatic lubrication fixes this by delivering small, frequent doses of clean grease, keeping the bearing in its ideal lubrication range around the clock.
Single-Point Automatic Lubricators
For a standalone bearing or a point that’s hard or unsafe to reach, a single-point lubricator is the simplest fix. Install it, set it, and it handles the greasing for you.
The lubricator mounts directly on the grease fitting, or remotely through a feed line, and dispenses a precise volume of grease over a set period, typically from one to twelve months. Electromechanical models use a battery-powered drive, so output stays consistent regardless of temperature or back pressure.
Features:
- Adjustable discharge period and reservoir sizes to match bearing size, speed, and duty
- Electromechanical drive for steady, repeatable output
- Simple push-button setup with LED status lights for at-a-glance checks
- Sealed, replaceable cartridges filled with the grease you specify, keeping contaminants out
- Direct or remote mounting to keep technicians away from moving and elevated equipment
Typical applications: rolling and plain bearings, slide guides, open gears and gear racks, spindles, shaft seals, and chains.
Multi-Point Lubrication Systems
When one machine has several grease points, servicing each one separately multiplies the time, the cost, and the chance of a missed point. A multi-point system covers them all from a single unit.
One drive and reservoir feed several lubrication points, each through its own line. Output can be set per outlet to match the equipment manufacturer’s recommendations, and the unit mounts in a safe, accessible spot away from the machine.
Features:
- Multiple outlets from a single drive and reservoir
- Discharge adjustable outlet by outlet to meet OEM specifications
- Remote mounting keeps refills and checks outside guards and off ladders
- Larger reservoirs for service intervals measured in months, not days
- Optional tie-in to machine controls for run-linked dispensing and fault alarms
Typical applications: linear guides, rolling and plain bearings, open gears, spindles, and conveyors, across industries such as pulp and paper, automotive, water and wastewater, chemical processing, and mining.
Where Automatic Lubrication Pays Off
- Centrifugal pump and motor bearings
- Fans, blowers, and cooling-tower drives
- Conveyors, idlers, and chain drives
- Mixers and agitators
- Open gears and gear racks
- Remote, elevated, or guarded lubrication points
